Straight answers and careful work on metal roof installation in Richardson, TX. Metal roofing is our specialty, but we do the whole roof.
A metal roof is what Roofing Brothers is known for, and it has been since 2002. On a Richardson home that means standing seam or exposed fastener panels set over sound decking and real underlayment, with the ridge, valley and eave trim cut and fit on site rather than forced out of a box.
When a Richardson homeowner calls us about metal roof installation, the first thing we do is come look. Somebody from the crew gets on the roof, checks the decking, flashing and fasteners, and works out what the job actually needs before a number is ever written down.
You get a written estimate for the metal roof installation on your Richardson home with the materials named and the price broken out, and that estimate is free. If we find something once the work starts, we stop, show you, and price it before we go any further.
What to expect once you call us out to look at your roof.
Nothing gets ordered until you have a written price in hand and have settled on the color you actually want.
Where the decking is sound and there is only one layer, we can often go over the top on purlins. We tell you which one your house calls for.
Synthetic underlayment over the whole roof, ice and water shield in the valleys and at the eaves, then panels set square on the correct fastener spacing.
Then the yard gets picked up, the scrap gets hauled off, and a magnet goes over the drive before we pull out.
Straight answers, no sales talk.
Around twenty standard colors. Green, burgundy, bronze, black, gray, tan and barn red are the ones most Richardson homeowners land on. We bring the chart with the estimate so you can hold it against your siding.
A straightforward Richardson house is usually three to five days. A cut up roof with dormers, valleys and multiple pitches takes longer, because every panel and trim piece gets measured and fit on site.
Most Richardson metal roof jobs land between about $12,000 and $30,000 in 2026, depending on square footage, pitch, panel type and how much tear off is involved. Standing seam runs higher than exposed fastener panels. We measure before we quote and the estimate is free.
Much less than people expect. Over solid decking with underlayment, a Richardson metal roof sounds about like a shingle roof from inside. The loud tin roof people remember was screwed to open purlins on a barn.
Our reputation is just the roofs behind us.
"Standing seam on our log home. The panels are dead straight and the ridge work is clean. You can tell they have done a few of these."
"Green metal over the whole house and the carport. Looks sharp, and it is quiet inside when it rains, which honestly surprised me."
"Twenty year old tin roof with screws backing out everywhere. They refastened the whole thing with new washers instead of talking me into a replacement I did not need."